Repair Smtp List Error TutorialHome > Smtp Error > Smtp List Error
Smtp List Error
Mailbox name invalid". X.1.8 Bad sender's system address The sender's system specified in the address does not exist or is incapable of accepting return mail. It's a (not very clever) strategy to prevent spamming. Vaudreuil IESG X.6.6 Message content not available 554 The message content could not be fetched from a remote system. http://unordic.com/smtp-error/smtp-error-list.html
Reply Arn Staff 35,172 Points 2016-06-10 12:06 pm Hello Cristian, I took a close look at the top-level-domain used for the email address (infovia.com.ar). Modern implementations SHOULD NOT advertise mechanisms that are not permitted due to lack of encryption, unless an encryption layer of sufficient strength is currently being employed. [RFC4954] (Standards Track) R. Kindest regards, Arnel C. Vaudreuil IESG X.5.5 Wrong protocol version Not given A protocol version mis-match existed which could not be automatically resolved by the communicating parties. [RFC3463] (Standards Track) G. http://www.serversmtp.com/en/smtp-error
Smtp Error Code
The mailbox has been corrupted or placed on an offline server, or your email hasn't been accepted for IP problems or blacklisting. This memo does not discuss the merits of any such filtering, but provides a mechanism to report such. Vaudreuil IESG X.6.2 Conversion required and prohibited Not given The content of the message must be converted before it can be delivered and such conversion is not permitted.
- The first sub-code indicates whether the delivery attempt was successful.
- I hope this helps to answer your question, please let us know if you require any further assistance.
- When I ran a WHOIS , traceroute, or ping, it would not recognize the domain.
SMTP provides about 12 useful codes for delivery reports. Melnikov IESG X.6.0 Other or undefined media error Not given Something about the content of a message caused it to be considered undeliverable and the problem cannot be well expressed with Servers should send only defined, registered status codes. Smtp Error Code 554 Kindest Regards, Scott M Reply grillo n/a Points 2015-07-03 12:49 pm site 2 weeks I cann't send with smtp service of yahoo, error 200 "unknow error certificate bad; destination host name
Also check additional recipients in CC and BCC. 553 Sorry, over your daily relay limit553 Too many mail553 Quota exceeded If you receive one of the above (or a similar) error Smtp Error Codes 550 Vaudreuil Standards Track [Page 8] RFC 3463 Enhanced Mail System Status Codes January 2003 3.5 Network and Routing Status X.4.0 Other or undefined network or routing status Something went wrong with X.2.3 Message length exceeds administrative limit A per-mailbox administrative message length limit has been exceeded. http://www.iana.org/assignments/smtp-enhanced-status-codes/smtp-enhanced-status-codes.xhtml Configure your settings providing a username+password authentication.
This memo does not discuss the merits of any such filtering, but provides a mechanism to report such. Smtp Error 451 Both the sender and recipient must permit the exchange of messages and arrange the exchange of necessary keys and certificates for cryptographic operations. [RFC3463] (Standards track) G. Vaudreuil IESG X.7.6 Cryptographic algorithm not supported Not given A transport system otherwise authorized to validate or decrypt a message was unable to do so because the necessary algorithm was not Detail sub-codes may provide notification of transformations required for delivery. 4.XXX.XXX Persistent Transient Failure A persistent transient failure is one in which the message as sent is valid, but persistence of
Smtp Error Codes 550
Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. In general a business account should have less mailing restrictions than a free account. Smtp Error Code Used in place of 5.7.1 as described in Section 8.4 of [RFC7208]. [RFC7372] (Standards Track); [RFC7208] (Standards Track) M. Smtp Enhanced Status Codes This limit may either be for physical or administrative reasons.
Vaudreuil IESG X.2.2 Mailbox full 552 The mailbox is full because the user has exceeded a per-mailbox administrative quota or physical capacity. weblink Vaudreuil IESG 4.XXX.YYY Persistent Transient Failure A persistent transient failure is one in which the message as sent is valid, but persistence of some temporary condition has caused abandonment or delay You should contact your ISP and ask them to allow you as a certified sender. This is useful only as a permanent error. [RFC3463] (Standards Track) G. Smtp Error Codes Rfc
and G. Vaudreuil IESG X.1.8 Bad sender's system address 451, 501 The sender's system specified in the address does not exist or is incapable of accepting return mail. If the error persists, check all your recipients' addresses and if you've been blacklisted. 541 The recipient address rejected your message: normally, it's an error caused by an anti-spam filter. http://unordic.com/smtp-error/smtp-error-messages-list.html Either your email has been blocked by the recipient's firewall, or there's a hardware problem.
This may be useful as a permanent, transient persistent, or successful delivery code. 4. Smtp Error 421 Edited the text to make it spell-checker and grammar checker compliant. Forgot your password?
You should try again sending smaller sets of emails instead of one big mail-out.432Typical side-message: "The recipient's Exchange Server incoming mail queue has been stopped".It's a Microsoft Exchange Server's SMTP error
In general a business account should have less mailing restrictions than a free account. Because the number space is large, it is not intended that published status codes will ever be redefined or eliminated. Web Hosting Business Hosting VPS Hosting Dedicated Servers Enterprise Hosting Solutions Reseller Hosting WordPress Hosting Launch AssistÔó Managed Hosting Domain Names Web Design Services Hosting Features SSD Hosting Shared cPanel Hosting Smtp Code 240 Vaudreuil IESG X.3.5 System incorrectly configured Not given The system is not configured in a manner that will permit it to accept this message. [RFC3463] (Standards Track) G.
A client which receives this may activate a security layer such as TLS prior to authenticating, or attempt to use a stronger mechanism. [RFC5248] (Best current practice) T. X.3.1 Mail system full Mail system storage has been exceeded. Vaudreuil IESG X.4.4 Unable to route Not given The mail system was unable to determine the next hop for the message because the necessary routing information was unavailable from the directory http://unordic.com/smtp-error/smtp-server-error-list.html It's recommended to use an email account from your own domain (website), your company mail server or a business email account.
Klensin IESG X.7.14 Trust relationship required 535, 554 The submission server requires a configured trust relationship with a third-party server in order to access the message content. Kucherawy IESG X.7.27 Sender address has null MX 550 This status code is returned when the associated sender address has a null MX, and the SMTP receiver is configured to reject Cookies & Privacy | About | Contact SMTP reply codes See rfc2821 for the basic specification of SMTP; see also rfc1123 for important additional information. See: License Agreement 1997-2016 Arclab.
The problem is that it will generally be very cryptic, like "550 Requested action not taken: mailbox unavailable" or "421 Try again later". Reply codes in numerical order Code Meaning 200 (nonstandard success response, see rfc876) 211 System status, or system help reply 214 Help message 220
If so, click the button below! These failures include the full range of problems resulting from implementation errors or an unreliable connection. If the used email account is too restrictive, use a different email account (and mail server) instead. These codes report failures due to translation, transcoding, or otherwise unsupported message media.
Allman IESG X.1.10 Recipient address has null MX 556 This status code is returned when the associated address is marked as invalid using a null MX. [RFC7505] (Standards Track); [RFC7504] (Standards Vaudreuil IESG X.4.3 Directory server failure 451, 550 The network system was unable to forward the message, because a directory server was unavailable. Vaudreuil Standards Track [Page 10] RFC 3463 Enhanced Mail System Status Codes January 2003 X.5.4 Invalid command arguments A valid mail transaction protocol command was issued with invalid arguments, either because